4000 Router Series Network Management and Monitoring Configuration Guide

# Display the results of the FTP operation.

[DeviceA] display nqa result admin test1

NQA entry (admin admin, tag test1) test results:

Send operation times: 1 Receive response times: 1

Min/Max/Average round trip time: 173/173/173

Square-Sum of round trip time: 29929

Last succeeded probe time: 2011-11-22 10:07:28.6

Extended results:

Packet loss ratio: 0%

Failures due to timeout: 0

Failures due to disconnect: 0

Failures due to no connection: 0

Failures due to internal error: 0

Failures due to other errors: 0

# Display the history records of the FTP operation.

[DeviceA] display nqa history admin test1

NQA entry (admin admin, tag test1) history records:

Index Response Status Time

1 173 Succeeded 2011-11-22 10:07:28.6

The output shows that Device A uses 173 milliseconds to upload a file to the FTP server.

HTTP operation configuration example

Network requirements

As shown in Figure 11, configure an HTTP operation on the NQA client to test the time required to obtain

data from the HTTP server.

Figure 11 Network diagram

Configuration procedure

# Assign each interface an IP address. (Details not shown.)

# Configure static routes or a routing protocol to make sure the devices can reach each other. (Details not

shown.)

# Create an HTTP operation.

<DeviceA> system-view

[DeviceA] nqa entry admin test1

[DeviceA-nqa-admin-test1] type http

# Specify the URL of the HTTP server.

[DeviceA-nqa-admin-test-http] url http://10.2.2.2/index.htm

# Configure the HTTP operation to get data from the HTTP server. (The default HTTP operation type is get,

and this step can be omitted.)