HP MSR2000/3000/4000 Router Series Voice Command Reference

9
simple: Specifies single data message format (SDMF).
Usage guidelines
The local and remote ends must use the same CID format.
The calling name in the CID can only be transmitted in MDMF format.
This command takes effect only on the terminating device.
Examples
# Set the CID format to SDMF on FXS interface 1/0.
<Sysname> system-view
[Sysname] subscriber-line 1/0
[Sysname-subscriber-line1/0] cid type simple
Related commands
• calling-name
• cid display
• cid send
• cid standard-type
cid standard-type
Use cid standard-type to configure the CID standard on an FXS interface.
Use undo cid standard-type to restore the default.
Syntax
cid standard-type { bellcore | brazil }
undo cid standard-type
Default
The bellcore mode is used.
Views
FXS interface view
Predefined user roles
2: System level
Parameters
bellcore: Specifies the bellcore standard that sends CID in frequency shift keying (FSK) mode. This
standard applies to most countries and regions such as China and North America.
brazil: Specifies the Brazil standard that sends CID in dual tone multi-frequency (DTMF) mode.
Usage guidelines
This command takes effect on the terminating device, which encapsulates CID by using the specified
standard and sends it to the called telephone.
The CID format configured by using the cid type command takes effect only when the bellcore standard
is used.