HP MSR2000/3000/4000 Router Series Voice Command Reference

15
This command might fail to restore the default settings for some commands for reasons such as command
dependencies or system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings for voice interface 1/0.
<Sysname> system-view
[Sysname] subscriber-line 1/0
[Sysname-subscriber-line1/0] default
delay hold
Use delay hold to configure the seizure signal duration in delay start mode for an E&M interface.
Use undo delay hold to restore the default.
Syntax
delay hold milliseconds
undo delay hold
Default
The seizure signal duration is 400 milliseconds.
Views
E&M interface view
Predefined user roles
network-admin
Parameters
milliseconds: Specifies the seizure signal duration in delay start mode, in the range of 100 to 5000
milliseconds.
Examples
# Set the seizure signal duration in delay start mode to 500 milliseconds for E&M interface 1/0.
<Sysname> system-view
[Sysname] subscriber-line 1/0
[Sysname-subscriber-line1/0] signal delay
[Sysname-subscriber-line1/0] delay hold 500
Related commands
signal
delay rising
Use delay rising to configure the delay time from when the terminating side detects a seizure signal to
when it sends the seizure signal in delay start mode.
Use undo delay rising to restore the default.