HP MSR2000/3000/4000 Router Series Voice Command Reference

36
ring-detect debounce
Use ring-detect debounce to configure the debounce time for ring detection.
Use undo ring-detect debounce to restore the default.
Syntax
ring-detect debounce value
undo ring-detect debounce
Default
The debounce time is 10 milliseconds.
Views
FXO interface view
Predefined user roles
network-admin
Parameters
value: Specifies the debounce time for ring detection, in the range of 4 to 15 milliseconds.
Usage guidelines
By setting different debounce times, you can detect ring signals of different frequencies and waveforms.
Do not set the debounce time during a conversation.
Do not set too short a debounce time. Otherwise, false detection might occur under the influence of
power line interference.
If you configure this command on an FXO interface of a card, the configuration takes effect on all FXO
interfaces of the card.
Examples
# Configure the debounce time for ring detection as 15 milliseconds on FXO interface 1/0.
<sysname> system-view
[sysname] subscriber-line 1/0
[sysname-subscriber-line1/0] ring-detect debounce 15
ring-detect frequency
Use ring-detect frequency to set the frequency value for ring detection.
Use undo ring-detect frequency to restore the default.
Syntax
ring-detect frequency value
undo ring-detect frequency
Default
The frequency for ring detection is 40 Hz.