HP MSR2000/3000/4000 Router Series Voice Command Reference

51
Views
R2 CAS view
Predefined user roles
network-admin
Examples
# Configure the terminating side to send a clear-back signal when the originating side first disconnects
the line.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-E1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-E1 1/0] cas 0
[Sysname-cas 1/0:0] clear-forward-ack enable
display voice subscriber-line
Use display voice subscriber-line to display information about digital voice interfaces.
Syntax
For E1 and T1 interfaces:
display voice subscriber-line line-number:{ ts-set-number | ts-set-number.sub-timeslot | 15 | 23 }
For BSV interfaces:
display voice subscriber-line line-number.subnumber
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
line-number: Specifies an E1 or T1 interface by its number.
ts-set-number: Specifies a timeslot set by its number.
sub-timeslot: Specifies a timeslot.
subnumber: Specifies a subinterface by its number 1 or 2.
15: Number for the PRI set created by bundling the timeslots of an E1 interface.
23: Number for the PRI set created by bundling the timeslots of a T1 interface.
Examples
# Display information about voice interface 1/0:0 generated on an E1 interface.
<Sysname> display voice subscriber-line 1/0:0
Current information subscriber-line1/0:0
Type: R2
Status: Up
Call status: