4000 Router Series Voice Command Reference

[Sysname-voice-dial-entity10] line 1/0

match-template

Use match-template to configure the number template for a voice entity.

Use undo match-template to remove the configuration.

Syntax

match-template match-string

undo match-template

Default

No number template is configured for a voice entity.

Views

POTS entity view, VoIP entity view

Predefined user roles

2: System level

Parameters

match-string: Specifies a number template, a string of 1 to 31 characters and in the format of [ + ] { string

[ T ] [ $ ] | T }. The following describe the characters:

• Plus sign (+): If the plus sign (+) is at the beginning of the string, the string indicates an E.164

standard number. For example, +110022 indicates 110022 is an E.164 standard number.

If a number starts with the plus sign (+), note the following when you use it on a trunk: The E&M,

R2, and LGS signaling use DTMF transmission, and since the plus sign (+) does not have a

corresponding audio, the number cannot be transmitted to the called side successfully. The DSS1

signaling uses ISDN transmission, the above problem does not exist. You should avoid using a

number that cannot be identified by the signaling itself. Otherwise, the call will fail.

• The dollar sign ($) is the last character, indicating the end of the number. That means the entire

called number must match the string part before the dollar sign ($). If the dollar sign is absent, the

number template matches all numbers beginning with the string.

• Dollar sign ($): Can only be at the end of the string. The number must exactly match the string

before the dollar sign. If the string has no dollar sign, the numbers starting with the string are

permitted. For example, the caller-permit 20 command permits all numbers starting with 20.

• T: Indicates the timer. It means the system is waiting for the subscriber to dial any number until: the

number length threshold is exceeded, the subscriber enters the terminator; or the timer expires.

• string: Consists of any characters of digits 0 through 9, and pound sign (#), asterisk (*), dot (.),

exclamation point (!), plus sign (+), percent sign (%), brackets ([ ]), parentheses (()), and hyphen (-).

Brackets ([ ]) or parentheses (( )) each occupy two characters, and other symbols each occupy one

character.

Table 11 de

scribes these characters.

Table 11 Description of the characters in a

string

Character Descri

tion

0-9 Digits 0 through 9.

Pound sign (#) or

asterisk (*)

Indicates a valid digit.