HP MSR2000/3000/4000 Router Series Voice Configuration Guide

45
Binding a digital voice interface to a POTS entity
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter voice dial program
view.
dial-program N/A
4. Create a POTS entity and
enter POTS entity view.
entity entity-number pots N/A
5. Bind a digital voice interface
to the POTS entity.
• For E1 and T1 interfaces:
line line-number:{ ts-set-number
| 15 | 23 }
• For BSV interfaces:
line line-number:
By default, no digital voice
interface is bound to the POTS
entity.
Displaying and maintaining digital voice interfaces
Execute display commands in any view.
Task Command
Display digital voice interfaces (for E1
or T1 interfaces).
display voice subscriber line line-number:{ ts-set-number |
ts-set-number.sub-timeslot | 15 | 23 }
Display digital voice interfaces (for
BSV interfaces).
display voice subscriber line { line-number |
ts-set-number.subnumber }
Digital voice interface configuration examples
This section provides configuration examples for digital voice interfaces.
R2 signaling configuration example
Network requirements
As shown in Figure 20, configure R2 signaling on the routers so the telephones can call each other.