4000 Router Series Voice Configuration Guide

[RouterA-voice-dial-entity1001] substitute called 1

When you use Telephone A to call number 0101001, VoIP entit y 1001 replaces 0101001 with 1001 and

sends the call to the destination address 1.1.1.2. Then Telephone B rings.

Configuring a priority for a voice entity

If a number matches multiple voice entities, the router selects the voice entity with the highest priority.

To configure a priority for a voice entity:

Step Command Remarks

1. Enter system view.

system-view N/A

2. Enter voice view.

voice-setup N/A

3. Enter dial program view.

dial-program N/A

4. Enter voice entity view.

entity entity-number { pots | voip }

N/A

5. Configure a priority for the

voice entity.

priority priority-order The default priority is 0.

Configuring a number sending mode

The number sending mode controls how the originating router sends a called number. The router

supports the following number sending modes:

• Sends the least significant digits of a called number (the number of the least significant digits is

specified with the send-number digit-number command).

• Sends all the digits of a called number.

• Sends a truncated called number. When the match-template command configured for a voice

entity contains dots ".", only the digits that match the dots are sent.

Procedure

To configure a number sending mode:

Step Command Remarks

1. Enter system view.

system-view N/A

2. Enter voice view.

voice-setup N/A

3. Enter dial program view.

dial-program N/A

4. Enter POTS voice entity view.

entity entity-number pots N/A

5. Configure a number sending

mode.

send-number { digit-number | all |

truncate }

By default, the truncate mode is

used.