HP MSR2000/3000/4000 Router Series Voice Configuration Guide

84
Ste
p
Command Remarks
5. Configure SIP credentials for
the POTS entity.
• user username password
{ cipher | simple } password
[ cnonce cnonce | realm
realm ] *
By default, no SIP credentials are
configured for a POTS entity.
Enabling a POTS entity to register with the registrar
Perform this task to enable a POTS entity to register with the registrar. You can also disable a POTS entity
to register with the registrar by using the undo register-number command if registration is not needed.
To enable a POTS entity to register with the registrar:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter dial program view.
dial-program N/A
4. Enter POTS entity view.
entity entity-number pots N/A
5. Enable the POTS entity to
register with the registrar.
register-number
By default, a POTS entity registers
with the registrar after UA
registration is configured.
Configuring registrar information
Perform this task to specify a registrar. The expires keyword sets the registration expiry time, and the
refresh-ratio keyword sets the refresh percentage. When the registration time reaches the registration
expiry time multiplied by the refresh percentage, a voice entity or SIP trunk re-registers the number with
the registrar to avoid expiration.
To configure registrar information:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter voice view.
voice-setup N/A
3. Enter SIP view.
sip N/A
4. Configure the registrar
information for the SIP
UA.
registrar registrar-index ip ip-address
[ port port-number ] [ expires seconds ]
[ refresh-ratio ratio-percentage ]
By default, no registrar information
is configured.
Displaying SIP UA registration status
Execute display commands in any view.