HP MSR3012/3024 Routers FIPS Enclosure Installation Guide

Phillips screwdriver

(User-supplied)

Needle-nose pliers

(User-supplied)

ESD-preventive wrist strap

(User-supplied)

Installation kit

Installing a FIPS enclosure on a router with front mounting brackets

HP MSR3012/3024 routers meet the requirement of FIPS security level 2.

Tool list

M4 countersunk-head screw

(Supplied with the router)

Mounting brackets

(Supplied with the router)

Opacity shield

M3 countersunk-

head screw

Hex bolt

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

Installation preparation

Wear an ESD-preventive wrist strap, and make sure that the wrist strap has a good

skin contact and is well grounded.

The installation procedures must be performed by qualified personnel.

Before installation, read the Compliance and Safety Manual for the compatible switch

of the opacity shield kit.

•

Face the front panel, install the front mounting brackets on both sides of the router and

secure them with M

4 countersunk-head screws, mount the router on a rack shelf (skip this

step if the router is not to be mounted on a rack), and attach the opacity shield.

Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any,

from where hex bolts are to be installed.)

Align the holes on the opacity shields with the hex bolts.

Press the opacity shields against the side panels, and use M3 countersunk-head screws to

secure the opacity shields.

Apply tamper-evidence labels to opacity shields, screws that secure the opacity shields,

field replaceable units (FRUs), USB ports, and air vents on interface cards and filler panels.

PAGE 1
Face the front panel, install the front mounting brackets on both sides of the router and secure them with M4 countersunk-head screws, mount the router on a rack shelf (skip this step if the router is not to be mounted on a rack), and attach the opacity shield. HP MSR3012/3024 routers meet the requirement of FIPS security level 2.
PAGE 2
MSR3024 Installing a FIPS enclosure on a router with rear mounting brackets Only use the screws and hex bolts that are supplied in the opacity shield kit to secure the opacity shield. Face the rear panel, install the rear mounting brackets on both sides of the router and secure them with M4 countersunk-head screws, mount the router on a rack shelf (skip this step if the router is not to be mounted on a rack), and attach the opacity shield. MSR3012 Install hex bolts on the chassis as shown in the figures.