HP MSR3012/3024 Routers FIPS Enclosure Installation Guide

MSR3024

MSR3012

Installing a FIPS enclosure on a router with rear mounting brackets

Face the rear panel, install the rear mounting brackets on both sides of the router and secure

them with M4 countersunk-head screws, mount the router on a rack shelf (skip this step if the

router is not to be mounted on a rack), and attach the opacity shield.

Only use the screws and hex bolts that are supplied in the opacity shield kit to secure

the opacity shield.

Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any,

from where hex bolts are to be installed.)

Align the holes on the opacity shields with the hex bolts.

Press the opacity shields against the side panels, and use M3 countersunk-head screws to

secure the opacity shields.

Apply tamper-evidence labels to opacity shields, screws that secure the opacity shields, field

replaceable units (FRUs), USB ports, and air vents on interface cards and filler panels.