HP MSR3044 Router FIPS Enclosure Installation Guide

Face the front panel, install the front mounting brackets on both sides of the router and

secure them with M4 countersunk-head screws, mount the router on a rack shelf (skip this

step if the router is not to be mounted on a rack), and attach the opacity shield.

Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any,

from where hex bolts 2 are to be installed.)

Align the holes on the opacity shields with the hex bolts.

Apply tamper-evidence labels to opacity shields, screws that secure the opacity shields, field

replaceable units (FRUs), USB ports, and air vents on interface cards and filler panels.

Press the opacity shields against the side

panels, and use M3 countersunk-head screws

to secure the opacity shields.

PAGE 1
Face the front panel, install the front mounting brackets on both sides of the router and secure them with M4 countersunk-head screws, mount the router on a rack shelf (skip this step if the router is not to be mounted on a rack), and attach the opacity shield. Install hex bolts on the chassis as shown in the figures. (Remove the fastening screws, if any, from where hex bolts 2 are to be installed.) Align the holes on the opacity shields with the hex bolts.