R0106-HP MSR Router Series ACL and QoS Configuration Guide(V7)

8
Configuring an IPv4 basic ACL
IPv4 basic ACLs match packets based only on source IP addresses.
To configure an IPv4 basic ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv4 basic ACL and
enter its view.
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv4 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the acl name acl-name
command to enter the view of a
named ACL.
3. (Optional.) Configure a
description for the IPv4 basic
ACL.
description text
By default, an IPv4 basic ACL has
no ACL description.
4. (Optional.) Set the rule
numbering step.
step step-value The default setting is 5.
5. Create or edit a rule.
rule [ rule-id ] { deny | permit }
[ counting | fragment | logging |
source { source-address
source-wildcard | any } |
time-range time-range-name |
vpn-instance vpn-instance-name ] *
By default, an IPv4 basic ACL does
not contain any rule.
The logging keyword takes effect
only when the module (for
example, packet filtering) that uses
the ACL supports logging.
6. (Optional.) Add or edit a rule
comment.
rule rule-id comment text
By default, no rule comments are
configured.
Configuring an IPv6 basic ACL
IPv6 basic ACLs match packets based only on source IP addresses.
To configure an IPv6 basic ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 basic ACL view
and enter its view.
acl ipv6 number acl-number
[ name acl-name ] [ match-order
{ auto | config } ]
By default, no ACL exists.
IPv6 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the acl ipv6 name
acl-name command to enter the
view of a named ACL.
3. (Optional.) Configure a
description for the IPv6 basic
ACL.
description text
By default, an IPv6 basic ACL has
no ACL description.
4. (Optional.) Set the rule
numbering step.
step step-value The default setting is 5.