R0106-HP MSR Router Series ACL and QoS Configuration Guide(V7)

ManualsBrandsHP ManualsNetwork HardwareHP MSR3024 TAA-compliant AC Router

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter interface or PVC view.

• Enter interface view:

interface interface-type

interface-number

• Enter PVC view:

a. interface atm

interface-number

b. pvc vpi/vci

N/A

3. Configure the FIFO queue

size.

qos fifo queue-length

queue-length

The default FIFO queue size is 75.

If the burst traffic is too heavy, increase

the queue length to make queue

scheduling more accurate.

Displaying and maintaining FIFO

Execute the display command in any view.

Task Command

Display the FIFO configuration and

statistics for an interface or PVC.

display qos queue fifo interface [ interface-type interface-number

[ pvc { pvc-name | vpi/vci } ] ]

Configuring WFQ

You must enable the rate limit function for the queuing function to take effect on these interfaces:

• Tunnel interfaces.

• Subinterfaces.

• HDLC link bundle interfaces.

• VT/dialer interfaces configured with PPPoE, PPPoA, PPPoEoA, PPPoFR, or MPoFR. (Frame relay

traffic shaping is not enabled on an interface configured with PPPoFR or MPoFR).

On an interface or PVC that is not enabled with WFQ, the qos wfq command can enable WFQ and

configure WFQ-related parameters. If WFQ has been enabled for the interface or PVC, the qos wfq

command can modify the WFQ-related parameters.

To configure WFQ:

Ste