R0106-HP MSR Router Series ACL and QoS Configuration Guide(V7)

Matched : 311 (Packets) 23243 (Bytes)

5-minute statistics:

Forwarded: 0/24 (pps/bps)

Dropped : 0/0 (pps/bps)

Operator: AND

Rule(s) :

If-match any

Behavior: be

-none-

Classifier: qppb

Matched : 0 (Packets) 0 (Bytes)

5-minute statistics:

Forwarded: 0/0 (pps/bps)

Dropped : 0/0 (pps/bps)

Operator: AND

Rule(s) :

If-match qos-local-id 1023

Behavior: qppb

Committed Access Rate:

CIR 2000 (kbps), CBS 125000 (Bytes), EBS 512 (Bytes)

Green action : pass

Yellow action : pass

Red action : discard

Green packets : 0 (Packets) 0 (Bytes)

Yellow packets: 0 (Packets) 0 (Bytes)

Red packets : 0 (Packets) 0 (Bytes)

QPPB configuration example in an IPv6 network

Network requirements

As shown in Figure 24, all routers run BGP.

Configure QPPB so that Router B can perform the following tasks:

• Receive routes.

• Set the QPPB IP precedence value.

• Use the QoS policy to limit the rate of traffic with a specific IP precedence value to 512 kbps.

Figure 24 Network diagram

Configuration procedure

1. Configure IPv6 addresses for each interface. (Details not shown.)