R0106-HP MSR Router Series ACL and QoS Configuration Guide(V7)

2. Configure BGP on Router A.

<RouterA> system-view

[RouterA] bgp 1000

[RouterA] peer 168::2 as-number 2000

[RouterA] peer 168::2 connect-interface gigabitethernet 2/1/1

[RouterA-bgp] address-family ipv6

[RouterA-bgp-ipv6] peer 168::2 enable

[RouterA-bgp-ipv6] import-route direct

[RouterA-bgp-ipv6] quit

[RouterA-bgp] quit

3. Configure Router B:

# Configure BGP.

<RouterB> system-view

[RouterB] bgp 2000

[RouterB] peer 168::1 as-number 1000

[RouterB] peer 168::1 connect-interface gigabitethernet 2/1/1

[RouterB-bgp] address-family ipv6

[RouterB-bgp-ipv6] peer 168::1 enable

[RouterB-bgp-ipv6] peer 168::1 route-policy qppb import

[RouterB-bgp-ipv6] quit

[RouterB-bgp] quit

# Configure a routing policy.

[RouterB] route-policy qppb permit node 0

[RouterB-route-policy-qppb-0] apply ip-precedence 4

[RouterB-route-policy-qppb-0] quit

# Enable QPPB on interface GigabitEthernet 2/1/0.

[RouterB] interface gigabitethernet 2/1/0

[RouterB-GigabitEthernet2/1/0] bgp-policy destination ip-prec-map

# Configure a QoS policy.

[RouterB] traffic classifier qppb

[RouterB-classifier-qppb] if-match ip-precedence 4

[RouterB-classifier-qppb] quit

[RouterB] traffic behavior qppb

[RouterB-behavior-qppb] car cir 512 red discard

[RouterB-behavior-qppb] quit

[RouterB] qos policy qppb

[RouterB-qospolicy-qppb] classifier qppb behavior qppb

[RouterB-qospolicy-qppb] quit

# Apply the QoS policy to the incoming traffic of GigabitEthernet 2/1/0.

[RouterB] interface gigabitethernet 2/1/0

[RouterB-GigabitEthernet2/1/0] qos apply policy qppb inbound

[RouterB-GigabitEthernet2/1/0] quit

Verifying the configuration

# Verify that the related routes on Router A take effect.

[RouterA] display ipv6 routing-table