R0106-HP MSR Router Series Fundamentals Command Reference(V7)

102
If the server parameters are specified, you are prompted to enter the username and password for logging
in to the FTP server.
Examples
# Log in to the FTP server 192.168.0.211, and specify the source IPv4 address for outgoing FTP packets
as 192.168.0.212.
<Sysname>ftp 192.168.0.211 source ip 192.168.0.212
Press CTRL+C to abort.
Connected to 192.168.0.211 (192.168.0.211).
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User (192.168.0.211:(none)): abc
331 Give me your password, please
Password:
230 Logged in successfully
Remote system type is MSDOS.
ftp>
ftp client source
Use ftp client source to specify the source IPv4 address for outgoing FTP packets.
Use undo ftp client source to restore the default.
Syntax
ftp client source { interface interface-type interface-number | ip source-ip-address }
undo ftp client source
Default
No source IPv4 address is configured for outgoing FTP packets. The device uses the primary IPv4 address
of the output interface for the route to the server as the source IP address.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies the source interface for establishing FTP connections.
The primary IPv4 address of the source interface is used as the source IP address of packets sent to a FTP
server. Make sure the interface is up and has the primary IPv4 address configured. Otherwise, the
transmission fails.
ip source-ip-address: Specifies the source IP address for outgoing FTP packets. It must be the IPv4 address
of an interface in up state. Otherwise, the transmission fails.
Usages guidelines
If you execute this command multiple times, the most recent configuration takes effect.
The source address specified with the ftp command takes precedence over the source address specified
with the ftp client source command.