R0106-HP MSR Router Series Fundamentals Configuration Guide(V7)

147
Completion time : Wed Sep 28 18:00:01 2013
--------------------------------- Job output -----------------------------------
<Sysname>system-view
System View: return to User View with Ctrl+Z.
[Sysname]interface GigabitEthernet 2/1/2
[Sysname-GigabitEthernet2/1/2]shutdown
Installing/removing HMIM modules
The following matrix shows the support of MSR routers for the HMIM module:
Hardware HMIM module com
p
atibilit
y
MSR2000 No
MSR3000 Yes
MSR4000 Yes
To install an HMIM module, insert it to a slot. You do not need to power off the device.
To remove an HMIM module, you must unmount it first.
To unmount an HMIM module, perform the following task in user view:
Task Command Remarks
Unmount an HMIM module. remove hmimslot slot-number
CAUTION:
Use this command with caution. This command
stops all services provided by the HMIM
module.
Disabling password recovery capability
Password recovery capability controls console user access to the device configuration and SDRAM from
Boot ROM menus. This feature also determines the method for handling console login password loss
(see Figure 56).
If p
assword recovery capability is enabled, a console user can access the device configuration without
authentication to configure new passwords.
If password recovery capability is disabled, console users must restore the factory-default configuration
before they can configure new passwords. Restoring the factory-default configuration deletes the
next-startup configuration files.
To enhance system security, disable password recovery capability.