R0106-HP MSR Router Series Fundamentals Configuration Guide(V7)

61
{ AT&D—Ignores DTR signals.
{ AT&K0—Disables local flow control.
{ AT&R1—Ignores RTS signals.
{ AT&S0—Forces DSR to remain on.
{ ATEQ1&W—Disables the modem from returning command responses and execution results,
and saves configuration.
To verify your configuration, enter AT&V to display the configuration results.
NOTE:
The configuration commands and output vary by modem. For more information, see the modem user
guide.
5. To ensure successful communication and to avoid data loss, verify that the AUX port uses the
following settings:
{ The default parity check, stop bits, and data bits settings.
{ A baud rate that is lower than the transmission rate of the modem.
In AUX line view, you can also manage modem dial-in users. For more information, see Layer
2–WAN Access Configuration Guide.
6. Launch the terminal emulation program on the PC and create a connection using the telephone
number of the device-side modem.
Figure 27 through Figure 30 show the co
nfiguration procedure in Windows XP HyperTerminal.
On Windows Server 2003, add the HyperTerminal program first, and then log in to and manage
the device as described in this document. On Windows Server 2008, Windows 7, Windows Vista,
or another operating system, obtain a third-party terminal control program first. Then, follow the
user guide or online help of that program to log in to the device.
Figure 27 Creating a connection