R0106-HP MSR Router Series Fundamentals Configuration Guide(V7)

63
IMPORTANT:
Do not directly close the HyperTerminal. Doing so can cause some modems to stay in use, and your
subsequent dial-in attempts will always fail.
To disconnect the PC from the device, execute the appropriate ATH command in the HyperTerminal. If the
command cannot be entered, type AT+ + + and press Enter. When the word OK appears, execute the
ATH command. The connection is terminated if OK is displayed. You can also terminate the connection
by clicking in the HyperTerminal window.
Configuring the device as a Telnet redirect server
The device can act as a Telnet redirect server to enable users to Telnet to and manage other devices
without knowing the devices' IP addresses, as shown in Figure 31.
Th
e managed devices can be connected to the device's AUX ports, asynchronous ports, or serial ports
operating in asynchronous mode. If AUX ports are used, you must disable login authentication for the
AUX lines.
The device can redirect only one Telnet connection at a time.
Figure 31 Telnetting to devices through a redirect server
Configuration procedure
To configure the device as a Telnet redirect server:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A