R0106-HP MSR Router Series Interface Command Reference(V7)

92
network-operator
Parameters
interface-number: Specifies a CE1/PRI interface by its number. If you do not specify this argument, this
command displays information about all CE1/PRI interfaces.
Examples
# Display information about E1 2/3/0.
<Sysname> display controller e1 2/3/0
E1 2/3/0
Current state: UP
Description: E1 2/3/0 Interface
Basic Configuration:
Work mode: E1 framed, Cable type: 75 Ohm unbalanced
Line code: hdb3, Source clock: slave
Idle code: 7e, Itf type: 7e, Itf number: 4, Loop back: not set
Alarm State:
Receiver alarm state is None
Historical Statistics:
Last clearing of counters: Never
Data in current interval (150 seconds elapsed):
Loss Frame Alignment: 0 seconds, Framing Error: 0 seconds
CRC Error: 0 seconds, Alarm Indication: 0 seconds
Loss-of-signals: 0 seconds, Code Violations: 0 seconds
Slip: 0 seconds, E-Bit error: 0 seconds
Table 13 Command output
Field Description
E1 2/3/0
Current state
Interface state.
Description Interface description.
Work mode Operating mode of the interface: E1 or CE1.
Cable type Cable type of the interface.
Source Clock
Operating mode of the source clock of the interface: master or
slave.
Line Code Line code: AMI or HDB3.
Idle Code Idle code; 7E or FF.
Itf type Interframe filling tag: 7E or FF.
Itf number Number of interframe filling tags between two successive frames.
Loopback Loopback state.
Historical Statistics Statistics on the interface.
Last clearing of counters Most recent time when statistics for the interface was cleared.