R0106-HP MSR Router Series Interface Command Reference(V7)

105
Data in Interval 2:
Line Code Violations: 0, Path Code Violations: 0
Ais Alarm: 0 seconds, Los Alarm: 900 seconds
Slip: 23 seconds, Fr Loss: 900 seconds
Line Err: 0 seconds, Degraded: 0 minutes
Errored: 0 seconds, Bursty Err: 0 seconds
Severely Err: 0 seconds, Unavail: 900 seconds
Total Data (last 2 15 minute intervals):
Line Code Violations: 0, Path Code Violations: 0
Ais Alarm: 0 seconds, Los Alarm: 2087 seconds
Slip: 52 seconds, Fr Loss: 2087 seconds
Line Err: 0 seconds, Degraded: 0 minutes
Errored: 0 seconds, Bursty Err: 0 seconds
Severely Err: 0 seconds, Unavail: 2087 seconds
Table 14 Command output
Field Descri
p
tion
T1 2/4/0
Current state
Physical state of the interface: up or down.
Description Description for the T1 interface.
Basic Configuration Basic configurations of the interface.
Work mode Operating mode of the T1 interface.
Cable type Cable type of the T1 interface.
Frame-format
Frame format configured on the T1 interface: ESF or
SF.
fdl FDL format: ANSI, ATT, or none.
Line code Line code: AMI or B8ZS.
Source clock
Source clock used by the interface: master for the
internal clock or slave for the line clock.
Data-coding Normal or inverted.
Idle code 0x7E or 0xFF.
Itf type Type of interframe filling tag: 0x7E or 0xFF.
Itf number Number of interframe filling tags.
Loop back
Loopback setting on the interface: local, payload,
remote, or not set.
Receiver alarm state is Loss-of-Signal Type of received alarm: none, LOS, LOF, RAI, or AIS.
Transmitter is sending remote alarm. Type of transmitted alarm: RAI, or none.
Pulse density violation detected
The detected pulse density is incompliant with the
specification.