R0106-HP MSR Router Series Interface Command Reference(V7)

112
Syntax
reset counters controller t1 [ interface-number ]
Views
User view
Predefined user roles
network-admin
Parameters
interface-number: Specifies a CT1/PRI interface by its number. If you do not specify this argument, the
command clears statistics for all CT1/PRI interfaces.
Usage guidelines
The reset counters interface command clears statistics for all interfaces.
To display CT1/PRI interface statistics, use the display controller t1 command.
Examples
# Clear statistics for CT1/PRI interface T1 2/4/0.
<Sysname> reset counters controller t1 2/4/0
Related commands
display controller t1
sendloopcode
Use sendloopcode to send remote loopback control code.
Syntax
sendloopcode { fdl-ansi-llb-down | fdl-ansi-llb-up | fdl-ansi-plb-down | fdl-ansi-plb-up |
fdl-att-plb-down | fdl-att-plb-up | inband-llb-down | inband-llb-up }
Default
No remote loopback control code is sent.
Views
CT1/PRI interface view
Predefined user roles
network-admin
Parameters
fdl-ansi-llb-down: Sends ANSI-compliant LLB deactivation request code in the FDL to remove remote
loopback.
fdl-ansi-llb-up: Sends ANSI-compliant line loopback (LLB) activation request code in the FDL to start
remote loopback.
fdl-ansi-plb-down: Sends ANSI-compliant PLB deactivation request code in the FDL to remove remote
loopback.
fdl-ansi-plb-up: Sends ANSI-compliant payload loopback (PLB) activation request code in the FDL to start
remote loopback.