R0106-HP MSR Router Series Interface Command Reference(V7)

145
Parameters
interface-number: Specifies a CE3 interface by its number.
Examples
# Enter the view of interface E3 2/4/0.
<Sysname> system-view
[Sysname] controller e3 2/4/0
[Sysname-E3 2/4/0]
display controller e3
Use display controller e3 to display information about CE3 interfaces.
Syntax
display controller e3 [ interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a CE3 interface by its number. If you do not specify this argument, the
command displays information about all CE3 interfaces.
Usage guidelines
This command also displays information about each E1 line on the CE3 interface if the interface is
operating in CE3 mode.
Examples
# Display information about E3 2/4/0.
<Sysname> display controller e3 2/4/0
E3 2/4/0
Current state: UP
Description: E3 2/4/0 Interface
Frame-format: G751, line code: HDB3, clock: slave
national-bit: 1, Current mode: CE3, loopback: not set, Alarm: none
ERROR: 2 BPV, 0 EXZ, 0 FrmErr, 0 FEBE
BERT state: (stopped, not completed)
Test pattern: 2^7, Status: Not Sync, Sync Detected: 0
Time: 2 minutes Time past: 2 minutes
Bit errors (since test started): 0 bits
Bits received (since test started): 0 Mbits
Bit errors (since latest sync): 0 bits
Bits received (since latest sync): 0 Mbits
E3 2/4/0 CE1 1: up
Frame-format: NO-CRC4, clock: slave, loopback: not set
Receiver alarm state: none