R0106-HP MSR Router Series Interface Command Reference(V7)

160
display controller t3
Use display controller t3 to display information about CT3 interfaces.
Syntax
display controller t3 [ interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a CT3 interface by its number. If you do not specify this argument, the
command displays information about all CT3 interfaces.
Usage guidelines
In addition to the state information about the CT3 interface, the command displays information about
each T1 line on the CT3 interface if the interface is operating in CT3 mode.
Examples
# Display information about T3 2/4/0.
<Sysname> display controller t3 2/4/0
T3 2/4/0
Current state: UP
Description: T3 2/4/0 Interface
Basic Configuration:
Work mode: CT3, cable length: 49 feet
Frame-format: C-BIT Parity, line code: B3ZS
Source clock: slave, loopback: not set
Alarm state:
Receiver alarm state is none
MDL state:
No message is sent now.
Message data elements:
EIC: line, LIC: line, FIC: line, UNIT: line
FI: line, PORT_NO: line, GEN_NO: line
Periodical detection: disabled
FEAC state:
No code is sent now.
Periodical detection is enabled, no code received now.
BERT state:(stopped, not completed)
Test pattern: 2^7, Status: Not Sync, Sync Detected: 0
Time: 0 minutes, Time past: 0 minutes
Bit errors (since test started): 0 bits
Bits received (since test started): 0 Mbits
Bit errors (since latest sync): 0 bits
Bits received (since latest sync): 0 Mbits