R0106-HP MSR Router Series Interface Command Reference(V7)

11
• reset counters interface
display counters rate
Use display counters rate to display traffic rate statistics of interfaces in up state over the last statistics
polling interval.
Syntax
display counters rate { inbound | outbound } interface [ interface-type [ interface-number |
interface-number.subnumber ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
interface-number.subnumber: Specifies a subinterface number, where interface-number is an interface
number, and subnumber is the number of a subinterface created under the interface. The value range for
the subnumber argument is 1 to 4094.
Usage guidelines
The statistics cover only interfaces in up state.
If an interface type is specified, the command displays traffic rate statistics for all up interfaces of the
specified type over the last statistics polling interval.
If no interface type is specified, the command displays traffic rate statistics for all up interfaces that have
traffic counters over the last statistics polling interval.
If an interface which is always down over the last statistics polling interval is specified, the system prompts
that the interface does not support the command.
You can use the flow-interval command to set the statistics polling interval.
Examples
# Display the inbound traffic rate statistics for all GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface gigabitethernet
Interface Total (pps) Broadcast (pps) Multicast (pps)
GE2/0/1 200 100 100
GE2/0/2 300 200 100
GE2/0/3 300 200 100
Overflow: More than 14 digits.
--: Not supported.