R0106-HP MSR Router Series Interface Command Reference(V7)

222
ATM interface commands
ATM interface commands are applicable to routers installed with ATM-OC3, ADSL2+, G.shdsl, or
G.shdsl.Bis interface cards.
Common ATM interface commands
bandwidth
Use bandwidth to configure the expected bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) is calculated with the following formula: Interface baud rate/1000.
Views
ATM interface view (including four physical types: OC-3c/STM-1, ADSL 2+, SHDSL_4WIRE, and
SHDSL_8WIRE_BIS)
ATM subinterface view
EFM interface view (physical type: SHDSL_8WIRE_BIS)
EFM subinterface view
Predefined user roles
network-admin
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth of an interface affects the link cost. For more information, see Layer 3—IP
Routing Configuration Guides.
Examples
# Set the expected bandwidth of interface ATM 2/4/0 to 50 kbps.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] bandwidth 50
default
Use default to restore the default settings for an interface.