R0106-HP MSR Router Series Interface Command Reference(V7)

225
Maximum Transmit Unit: 1500
Internet protocol processing: disabled
AAL enabled: AAL5
Current VCs: 0 (0 on main interface)
ATM over E1, Scramble: enabled, Frame-format: crc4-adm
Code: hdb3, Clock: slave, Cable length: long
Loopback: cell
Cable type: 75 ohm non-balanced
Line Alarm: LOS LOF
Line Error: 0 FERR, 0 LCV, 0 CERR, 0 FEBE
Last clearing of counters: Never
Last 300 seconds input rate: 0.00 bytes/sec, 0.00 packets/sec
Last 300 seconds output rate: 0.00 bytes/sec, 0.00 packets/sec
Input:
0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns, 0 no buffer
Output:
0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns
# Display brief information about interface ATM 2/4/0.
<Sysname> display interface atm 2/4/0 brief
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
ATM2/4/0 UP UP(s) --
# Display brief information, including the causes, for all ATM interfaces in physically DOWN state.
<Sysname> display interface atm brief down
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
ATM2/4/0 DOWN Not connected
Table 25 Command output
Field Descri
p
tion
ATM2/4/0
Current state
Physical and administrative states of the interface:
• DOWN (Administratively)—The interface is shut down with
the shutdown command, and the interface is
administratively down.
• DOWN—The interface is administratively up but physically
down (typically because no physical link is present or the link
has failed).
• UP—The interface is both physically and administratively up.
Line protocol state Link layer protocol state of the interface: UP or DOWN.