R0106-HP MSR Router Series Interface Command Reference(V7)

237
The ADSL interfaces on the two ends must be configured with the same standard.
The standard that you specify takes effect when you re-activate the interface by either the shutdown and
undo shutdown commands or the activate and undo activate commands.
Examples
# Apply the standard T1.413 on interface ATM 1/0.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-ATM1/0] adsl standard t1413
adsl tx-attenuation
Use adsl tx-attenuation to set a transmission power attenuation for an ADSL interface.
Use undo adsl tx-attenuation to restore the default.
Syntax
adsl tx-attenuation attenuation
undo adsl tx-attenuation
Default
The transmission power attenuation is 0 (no attenuation).
Views
ATM ADSL 2+ interface view
Predefined user roles
network-admin
Parameters
attenuation: Specifies the transmission power attenuation in the range of 0 to 12 dB.
Usage guidelines
A higher attenuation value means a lower transmission power. A high transmission power might affect
the signals of other ADSL interfaces.
Examples
# Set the transmission power attenuation to 10 for ATM ADSL interface ATM 1/0.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-ATM1/0] adsl tx-attenuation 10
display dsl configuration
Use display dsl configuration to display the configurations for an ADSL interface.
Syntax
display dsl configuration interface atm interface-number
Views
Any view