R0106-HP MSR Router Series Interface Command Reference(V7)

249
b: Specifies the Annex B standard.
Usage guidelines
If the CO equipment and the CPE use different Annex standards, the line cannot be activated.
Annex A is dominant in North America and Annex B is dominant in Europe. When you set the annex
standard, consider the standard used in your region.
Examples
# Set G.SHDSL interface ATM 1/0 to adopt annex A.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-ATM1/0] shdsl annex a
shdsl capability
Use shdsl capability to set the capacity type for a G.SHDSL interface.
Use undo shdsl capability to restore the default.
Syntax
shdsl capability { auto | g-shdsl | g-shdsl-bis }
undo shdsl capability
Default
In CPE mode, the auto type is applied.
In CO mode, the g-shdsl-bis type is applied.
Views
ATM SHDSL_8WIRE_BIS interface view
Predefined user roles
network-admin
Parameters
auto: Specifies the auto type (available only in CPE mode).
g-shdsl: Specifies the G.SHDSL type.
g-shdsl-bis: Specifies the G.SHDSL.bis type.
Usage guidelines
In CPE mode, the g-shdsl, g-shdsl-bis, and auto keywords are available.
In CO mode, only the g-shdsl and g-shdsl-bis keywords are available.
When you configure the shdsl mode command, the default settings in each mode are automatically
restored.
Interfaces on the two ends must be configured with the same capacity type.
Examples
# Configure the capacity type for interface ATM 1/0 as G.SHDSL.
<Sysname> system-view
[Sysname] interface atm 1/0