R0106-HP MSR Router Series Interface Command Reference(V7)

256
Usage guidelines
When you configure the shdsl wire command, select the correct wire mode according to the
configurations of the remote interface. If you cannot determine the wire mode of the remote interface,
configure the local interface to operate in the auto mode.
Examples
# Set SHDSL_4WIRE ATM interface ATM 1/0 to operate in the four-wire automatic mode.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-ATM1/0] shdsl wire 4-auto-enhanced
EFM interface commands
This section introduces the eight-wire G.SHDSL.BIS interfaces.
display dsl configuration
Use display dsl configuration to display the configurations for an EFM interface.
Syntax
display dsl configuration interface efm interface-number
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface efm interface-number: Specifies an EFM interface by its number.
Examples
# Display the configurations for EFM interface EFM 2/0.
<Sysname> display dsl configuration interface efm 2/0
G.SHDSL.bis configuration
Mode: CPE
Standard: G.SHDSL.bis
Annex: b
Wire Type: 8
Line Rate: auto
Current Margin: 2 dB
Worst Margin: 0 dB
Psd Mode: Symmetric PSD
Pbo value: auto
PAM : auto
line-probing : enable
capability : auto
card-mode : efm