R0106-HP MSR Router Series Interface Command Reference(V7)

Field Description

Line protocol state

Link layer state of the interface. The state is determined through

parameter negotiation on the link layer.

• UP—The interface is up at the data link layer.

• UP (spoofing)—The link layer protocol of the interface is UP, but

its link is an on-demand link or not present at all. This attribute is

typical of Null interfaces and loopback interfaces.

• DOWN—The interface is down at the data link layer.

• DOWN (BFD)—The link layer of the interface is down because

BFD detected that the link failed.

• DOWN (DLDP)—The link layer of the interface is down because

DLDP detected that the link was unidirectional.

• DOWN (LAGG)—The link layer of the interface is down because

the aggregate interface does not have Selected ports.

• DOWN (DLDP, LAGG)—The link layer of the interface is shut

down by DLDP and LAGG.

• DOWN (DLDP, BFD)—The link layer of the interface is shut down

by DLDP and BFD.

• DOWN (LAGG)—The link layer of the interface is shut down by

LAGG.

• DOWN (LAGG, BFD)—The link layer of the interface is shut

down by LAGG and BFD.

• DOWN (DLDP, LAGG, BFD)—The link layer of the interface is

shut down by DLDP, LAGG, and BFD.

Bandwidth Expected bandwidth of the interface.

Maximum Transmit Unit MTU of the interface.

Internet protocol processing: disabled Indicates that the interface cannot process IP packets.

Internet Address is 192.168.1.200/24

Primary

Primary IP address of the interface.

IP Packet Frame Type

Ethernet framing format. PKTFMT_ETHNT_2 indicates that the

frames are encapsulated in Ethernet II framing format.

Hardware address MAC address of the interface.

IPv6 Packet Frame Type IPv6 packet framing format.

Loopback: not set No loopback test is running on the Ethernet interface.

promiscuous mode: not set Promiscuous mode is not configured on the Ethernet interface.

link type: autonegotiation The link type of the interface is autonegotiated.

flow-control: disabled Flow control is disabled on the Ethernet interface.

Loopback is set internal An internal loopback test is running on the Ethernet interface.

Loopback is not set No loopback test is running on the Ethernet interface.

10Mbps-speed mode The interface is operating at 10 Mbps.

100Mbps-speed mode The interface is operating at 100 Mbps.

1000Mbps-speed mode The interface is operating at 1000 Mbps.

10Gbps-speed mode The interface is operating at 10 Gbps.