R0106-HP MSR Router Series Interface Command Reference(V7)

262
Field Descri
p
tion
Last 5 seconds output rate 0.00 bytes/sec, 0
bits/sec, 0.00 packets/sec
Average output rate over the most recent 5 seconds:
• bytes/sec—Average bytes output every second.
• packets/sec—Average packets output every second.
Input:
0 packets, 0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens, 0 giants
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns, 0 no buffer
Packet receiving parameters:
• packets—Number of total packets received.
• bytes—Number of total bytes received.
• buffers—Number of buffers used to receive packets.
• errors—Number of errored packets detected at the physical
layer.
• crcs—Number of CRC errors.
• lens—Number of packets received with invalid lengths.
• giants—Number of packets received with lengths exceeding
the specified value.
• pads—Number of errors occurred in the padding process.
• aborts—Number of abnormal errors.
• timeouts—Number of packet receiving timeouts.
• overflows—Number of chip FIFO overflow errors occurred.
• overruns—Number of packets not processed due to higher
receiving rate than the forwarding rate.
• no buffer—Number of errors caused by insufficient system
resources.
Output:
0 packets, 0 bytes, 0 buffers
0 errors, 0 overflows, 0 underruns
Packet transmission parameters:
• packets—Number of total packets transmitted.
• bytes—Number of total bytes transmitted.
• buffers—Number of buffers used to transmit packets.
• errors—Number of errored packets detected at the physical
layer.
• overflows—Number of chip FIFO overflow errors occurred.
• underruns—Number of packets not transmitted due to lower
memory reading rate than the forwarding rate.
Brief information on interface(s) under route
mode
Brief information about the Layer 3 interfaces.
Link: ADM - administratively down; Stby -
standby
Link layer state of the interface:
• ADM—The interface was shut down by the network
administrator. To recover its physical layer state, use the
undo shutdown command.
• Stby—The interface is a backup interface. You can use the
display interface-backup state command to check the
corresponding primary interface.
Protocol: (s) - spoofing
If the protocol attribute of an interface includes the spoofing flag
(an s in parentheses), the data link layer protocol state of the
interface is shown as UP, but its link is an on-demand link or not
present.
Interface Abbreviation of the interface name.