R0106-HP MSR Router Series Interface Command Reference(V7)

19
Field Description
Unknown-speed mode
The speed of the interface is unknown because the speed
negotiation fails or the interface is physically disconnected.
half-duplex mode The interface is operating in half duplex mode.
full-duplex mode The interface is operating in full duplex mode.
unknown-duplex mode
The duplex mode of the interface is unknown because the duplex
mode negotiation fails or the interface is physically disconnected.
Link speed type is force link
The interface is configured with a specific speed, for example, 10
Mbps or 100 Mbps, by using the speed command.
link duplex type is autonegotiation The interface is configured with the duplex auto command.
link duplex type is force link
The interface is configured with a specific duplex mode, for
example, half or full, by using the duplex command.
Flow-control is not enabled Generic flow control is disabled on the interface.
The Maximum Frame Length Maximum Ethernet frame length allowed on the interface.
Allow jumbo frame to pass The interface allows jumbo frames to pass through.
Broadcast MAX-
Broadcast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Multicast MAX-
Multicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Unicast MAX-
Unicast storm suppression threshold in ratio, pps, or kbps. The unit
of the threshold depends on your configuration.
PVID Port VLAN ID (PVID) of the Ethernet interface.
Mdi type
Cable type (depending on your configuration):
• automdix.
• mdi.
• mdix.
Port link-type
Link type of the interface (depending on your configuration):
• access.
• trunk.
• hybrid.
Tagged VLAN ID
VLANs for which the interface sends packets without removing
VLAN tags.
Untagged VLAN ID
VLANs for which the interface sends packets after removing VLAN
tags.
Port priority Priority of the interface.
Last 300 seconds input: 0 packets/sec 0
bytes/sec 0%
Last 300 seconds output: 0 packets/sec
0 bytes/sec 0%
Average rate of inbound and outbound traffic in the last 300
seconds, in pps and Bps, and the ratio of the actual rate to the
maximum interface rate.
A hyphen (-) indicates that the statistical item is not supported.