R0106-HP MSR Router Series Interface Command Reference(V7)

271
4-standard: Specifies the four-wire standard mode. In this mode, the two pairs of these four wires must
start negotiation at the same time. In addition, the remote end must be set to operate in four-wire
standard mode as well.
6: Specifies the six-wire mode.
8: Specifies the eight-wire mode.
auto: Specifies the automatic mode. The local end uses the operating mode of the remote end to
negotiate with the remote end.
Usage guidelines
When you configure the shdsl wire command, select the correct wire mode according to the
configurations of the remote interface. If you are not sure of the wire mode of the remote end, use the
automatic mode for the local end to negotiate with the remote end.
Examples
# Set four-wire EFM interface EFM 2/4/0 to operate in the four-wire automatic mode.
<Sysname> system-view
[Sysname] interface efm 2/4/0
[Sysname-EFM2/4/0] shdsl wire 4-auto-enhanced