R0106-HP MSR Router Series IP Multicast Command Reference(V7)

118
Parameters
interval: Sets the override interval in the range of 1 to 65535 milliseconds.
Usage guidelines
You can set the override interval in PIM view or interface view. The configurations made in PIM view are
effective on all interfaces. The configurations made in interface view are effective on only the current
interface. If you set the override interval in both PIM view and interface view, the configuration in
interface view always takes precedence.
Examples
# Set the override interval to 2000 milliseconds on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] pim hello-option override-interval 2000
Related commands
• hello-option lan-delay (PIM view)
• hello-option override-interval (PIM view)
• pim hello-option lan-delay
pim holdtime join-prune
Use pim holdtime join-prune to set the joined/pruned state holdtime timer on an interface.
Use undo pim holdtime join-prune to restore the default.
Syntax
pim holdtime join-prune time
undo pim holdtime join-prune
Default
The joined/pruned state holdtime timer is 210 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
time: Sets the joined/pruned state holdtime timer in the range of 1 to 65535 seconds.
Usage guidelines
You can set the joined/pruned state holdtime timer in PIM view or interface view. The configurations
made in PIM view are effective on all interfaces. The configurations made in interface view are effective
on only the current interface. If you set the joined/pruned state holdtime timer in both PIM view and
interface view, the configuration in interface view always takes precedence.
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages to be less than the joined/pruned state holdtime timer.