R0106-HP MSR Router Series IP Multicast Command Reference(V7)

130
[Sysname-acl-basic-2000] rule permit source 232.1.0.0 0.0.255.255
[Sysname-acl-basic-2000] quit
[Sysname] pim
[Sysname-pim] ssm-policy 2000
state-refresh-interval (PIM view)
Use state-refresh-interval to configure the interval for sending state refresh messages.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refresh-interval
Default
The interval for sending state refresh messages is 60 seconds.
Views
PIM view
Predefined user roles
network-admin
Parameters
interval: Specifies the interval for sending state refresh messages, in the range of 1 to 255 seconds.
Examples
# Set the interval for sending state refresh messages to 70 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
Related commands
• pim state-refresh-capable
• state-refresh-rate-limit (PIM view)
• state-refresh-ttl (PIM view)
state-refresh-rate-limit (PIM view)
Use state-refresh-rate-limit to configure the time that the router waits before accepting a new state
refresh message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it accepts a new state refresh message.