R0106-HP MSR Router Series IP Multicast Command Reference(V7)

144
[Sysname-acl-adv-3101] rule permit ip source 10.10.0.0 0.0.255.255 destination 225.1.0.0
0.0.255.255
[Sysname-acl-adv-3101] quit
[Sysname] msdp
[Sysname-msdp] import-source acl 3101
Related commands
peer sa-policy
msdp
Use msdp to enable MSDP and enter MSDP view.
Use undo msdp to disable MSDP and remove the configurations in MSDP view to release the resources
occupied by MSDP.
Syntax
msdp [ vpn-instance vpn-instance-name ]
undo msdp [ vpn-instance vpn-instance-name ]
Default
MSDP is disabled.
Views
System view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify any VPN instance, the command applies to the public
network.
Usage guidelines
You must enable IP multicast routing in the VPN instance or on the public network before you use this
command.
Examples
# Enable IP multicast routing and MSDP on the public network, and enter public network MSDP view.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib] quit
[Sysname] msdp
[Sysname-msdp]
Related commands
multicast routing
originating-rp
Use originating-rp to configure an interface address as the RP address of SA messages.