R0106-HP MSR Router Series IP Multicast Command Reference(V7)

224
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify any VPN instance, the command displays RPF information for
IPv6 multicast sources on the public network.
ipv6-source-address: Specifies an IPv6 multicast source address.
ipv6-group-address: Specifies an IPv6 multicast group address in the range of FFxy::/16 (excluding
FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where "x" and "y" represent any hexadecimal numbers
from 0 to F.
Examples
# Display all RPF information of the multicast source with an IPv6 address 2001::101 on the public
network.
<Sysname> display ipv6 multicast rpf-info 2001::101
RPF information about source 2001::101:
RPF interface: GigabitEthernet2/1/1, RPF neighbor: FE80::A01:101:1
Referenced prefix/prefix length: 2001::/64
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 65 Command output
Field Descri
p
tion
RPF information about source 2001::101 RPF information of the IPv6 multicast source 2001::101.
RPF interface Type and number of the RPF interface.
RPF neighbor IPv6 address (link-local address) of the RPF neighbor.
Referenced prefix/prefix length Referenced route and prefix length.
Referenced route type
Type of the referenced route:
• igp—IPv6 IGP unicast route.
• egp—IPv6 EGP unicast route.
• unicast (direct) —IPv6 directly connected unicast route.
• unicast—Other IPv6 unicast route, such as IPv6 unicast
static route.
Route selection rule
RPF route selection rule: An RPF route can be selected by the
priority of the routing protocol or by the longest match of the
destination address in the routing table.
Load splitting rule Whether the load sharing rule is enabled.
Related commands
• display ipv6 multicast forwarding-table
• display ipv6 multicast routing-table
ipv6 multicast boundary
Use ipv6 multicast boundary to configure an IPv6 multicast forwarding boundary.
Use undo ipv6 multicast boundary to delete an IPv6 multicast forwarding boundary.