R0106-HP MSR Router Series IP Multicast Command Reference(V7)

299
Related commands
ipv6 pim timer hello
timer join-prune (IPv6 PIM view)
Use timer join-prune to configure the global interval for sending the join/prune messages.
Use undo timer join-prune to restore the default.
Syntax
timer join-prune interval
undo timer join-prune
Default
The global interval for sending the join/prune messages is 60 seconds.
Views
IPv6 PIM view
Predefined user roles
network-admin
Parameters
interval: Sets the global interval for sending the join/prune messages, in the range of 0 to 18000
seconds. If you set the value to 0, no join or prune messages are sent.
Usage guidelines
You can set the interval for sending the join/prune messages in IPv6 PIM view or interface view. The
configurations made in IPv6 PIM view are effective on all interfaces. The configurations made in interface
view are effective on only the current interface. If you set the interval in both IPv6 PIM view and interface
view, the configuration in interface view always takes precedence.
The configuration takes effect after the current interval ends.
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages to be less than the joined/pruned state holdtime timer.
Examples
# Set the global interval for sending the join/prune messages to 80 seconds on the public network.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] timer join-prune 80
Related commands
• holdtime join-prune (IPv6 PIM view)
• ipv6 pim timer join-prune