R0106-HP MSR Router Series IP Multicast Command Reference(V7)

78
has failed in the IGMP querier election, you must enable multicast forwarding capability on this interface.
Otherwise, downstream hosts cannot receive multicast data.
Examples
# Enable multicast forwarding on GigabitEthernet 2/1/1. (GigabitEthernet 2/1/1 is a non-querier
downstream interface on the IGMP proxy device.)
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] igmp proxy forwarding
igmp query-interval
Use igmp query-interval to set the IGMP general query interval on an interface.
Use undo igmp query-interval to restore the default.
Syntax
igmp query-interval interval
undo igmp query-interval
Default
The IGMP general query interval is 125 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
interval: Specifies the IGMP general query interval in the range of 1 to 31744 seconds.
Examples
# Set the IGMP general query interval to 60 seconds on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] igmp query-interval 60
igmp static-group
Use igmp static-group to configure an interface as a static member of a multicast group.
Use undo igmp static-group to restore the default.
Syntax
igmp static-group group-address [ source source-address ]
undo igmp static-group { all | group-address [ source source-address ] }
Default
An interface is not a static member of any multicast groups.
Views
Interface view