R0106-HP MSR Router Series IP Multicast Configuration Guide(V7)

237

Figure 70 Network diagram

Configuration procedure

1. Assign an IPv6 address and prefix length to each interface according to Figure 70. (Details not

shown.)

2. Configure Router A:

# Enable IPv6 multicast routing.

<RouterA> system-view

[RouterA] ipv6 multicast routing

[RouterA-mrib6] quit

# Enable MLD on GigabitEthernet 2/1/1.

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] mld enable

[RouterA-GigabitEthernet2/1/1] quit

# Enable IPv6 PIM-DM on GigabitEthernet 2/1/2.

[RouterA] interface gigabitethernet 2/1/2

[RouterA-GigabitEthernet2/1/2] ipv6 pim dm

[RouterA-GigabitEthernet2/1/2] quit

3. Configure Switch A:

# Enable MLD snooping globally.

<SwitchA> system-view

[SwitchA] mld-snooping

[SwitchA-mld-snooping] quit

# Create VLAN 100, assign GigabitEthernet 2/1/1 through GigabitEthernet 2/1/4 to the VLAN,

and enable MLD snooping and dropping IPv6 unknown multicast data for the VLAN.

[SwitchA] vlan 100

[SwitchA-vlan100] port gigabitethernet 2/1/1 to gigabitethernet 2/1/4

[SwitchA-vlan100] mld-snooping enable

[SwitchA-vlan100] mld-snooping drop-unknown

[SwitchA-vlan100] quit