R0106-HP MSR Router Series IP Multicast Configuration Guide(V7)

307
Configuring the IPv6 SSM group range
When an IPv6 PIM-SM enabled interface receives an IPv6 multicast packet, it checks whether the IPv6
multicast group address of the packet is in the IPv6 SSM group range. If the IPv6 multicast group address
is in this range, the IPv6 PIM mode for this packet is IPv6 PIM-SSM. If the IPv6 multicast group address is
not in this range, the IPv6 PIM mode is IPv6 PIM-SM.
Configuration guidelines
• Perform the following configuration on all routers in the IPv6 PIM-SSM domain.
• Make sure the same IPv6 SSM group range is configured on all routers in the entire domain.
Otherwise, IPv6 multicast information cannot be delivered through the IPv6 SSM model.
• When a member of an IPv6 multicast group in the IPv6 SSM group range sends an MLDv1 report
message, the device does not trigger a (*, G) join.
Configuration procedure
To configure an IPv6 SSM group range:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
ipv6 pim
N/A
3. Configure the IPv6 SSM group
range.
ssm-policy acl6-number
The default range is FF3x::/32,
where x can be any valid scope.
Configuring common IPv6 PIM features
Configuration task list
Task at a
g
lance
(Optional.) Configuring an IPv6 multicast data filter
(Optional.) Configuring a hello message filter
(Optional.) Configuring IPv6 PIM hello message options
(Optional.) Configuring common IPv6 PIM timers
(Optional.) Setting the maximum size of each join or prune message
(Optional.) Enabling BFD for IPv6 PIM
(Optional.) Enabling SNMP notifications for IPv6 PIM
Configuration prerequisites
Before you configure common IPv6 PIM features, complete the following tasks:
• Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure IPv6 PIM-DM or IPv6 PIM-SSM.