R0106-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V7)

15
Usage guidelines
To display the global link-aggregation load sharing criteria, execute the command without the interface
keyword.
To display all group-specific load sharing criteria, execute the command with the interface keyword, but
do not specify a particular interface.
To display the load sharing criteria of a particular aggregation group, execute the command with the
aggregate interface specified.
The route-aggregation keyword becomes available only after you create Layer 3 aggregate interfaces
on the device.
Examples
# Display the default global link-aggregation load sharing criteria.
<Sysname> display link-aggregation load-sharing mode
load-sharing mode
Link-Aggregation Load-Sharing Mode:
Layer 3 traffic: destination-ip address source-ip address
ip-protocol
Layer 4 traffic: destination-port source-port
MPLS traffic : mpls-label1
# Display the configured global link-aggregation load sharing criteria.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-ip address source-ip address destination-port
source-port
# Display the default link-aggregation load sharing criteria of the aggregation group that corresponds to
Layer 3 aggregate interface Route-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface route-aggregation 10
Route-Aggregation10 Load-Sharing Mode:
Link-Aggregation Load-Sharing Mode:
Layer 3 traffic: destination-ip address source-ip address
ip-protocol
Layer 4 traffic: destination-port source-port
MPLS traffic : mpls-label1
# Display the configured link-aggregation load sharing criterion or criteria of the aggregation group
corresponding to Layer 3 aggregate interface Route-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface route-aggregation 10
Route-Aggregation10 Load-Sharing Mode:
destination-ip address source-ip address destination-port
source-port