R0106-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V7)

26
Default
Link-aggregation traffic redirection is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
When you shut down a Selected port in an aggregation group, this feature redirects traffic to other
Selected ports. Zero packet loss is guaranteed for known unicast traffic, but not for unknown unicast
traffic. (MSR2000/MSR3000)
When you restart a card that contains Selected ports, this feature redirects traffic to other cards. Zero
packet loss is guaranteed for known unicast traffic, but not for unknown unicast traffic. (MSR4000)
Link-aggregation traffic redirection applies only to dynamic link aggregation groups.
To prevent traffic interruption, enable link-aggregation traffic redirection on devices at both ends of the
aggregate link.
Do not enable both spanning tree and link-aggregation traffic redirection at the same time, because light
packet loss might occur when a card or the device reboots.
Examples
# Enable link-aggregation traffic redirection.
<Sysname> system-view
[Sysname] link-aggregation lacp traffic-redirect-notification enable
link-aggregation load-sharing mode
Use link-aggregation load-sharing mode to configure the link-aggregation load sharing criteria.
Use undo link-aggregation load-sharing mode to restore the default setting.
Syntax
link-aggregation load-sharing mode { destination-ip | destination-port | source-ip | source-port }
undo link-aggregation load-sharing mode
Views
Layer 3 aggregate interface view
Predefined user roles
network-admin
Parameters
destination-ip: Performs load sharing in link aggregation groups based on destination IP address.
destination-port: Performs load sharing in link aggregation groups based on destination port.
source-ip: Performs load sharing in link aggregation groups based on source IP address.
source-port: Performs load sharing in link aggregation groups based on source port.