R0106-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V7)

120

• An MED device and Router B are connected to GigabitEthernet 2/1/1 and GigabitEthernet 2/1/2

of Router A, respectively.

Enable LLDP globally on Router A and Router B to perform the following tasks:

• Monitor the link between Router A and Router B on the NMS.

• Monitor the link between Router A and the MED device on the NMS.

Figure 36 Network diagram

Configuration procedure

1. Configure Router A:

# Enable LLDP globally.

<RouterA> system-view

[RouterA] lldp global enable

# Enable LLDP on GigabitEthernet 2/1/1. By default, LLDP is enabled on ports.

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] lldp enable

# Set the LLDP operating mode to Rx on GigabitEthernet 2/1/1.

[RouterA-GigabitEthernet2/1/1] lldp admin-status rx

[RouterA-GigabitEthernet2/1/1] quit

# Enable LLDP on GigabitEthernet 2/1/2. By default, LLDP is enabled on ports.

[RouterA] interface gigabitethernet 2/1/2

[RouterA-GigabitEthernet2/1/2] lldp enable

# Set the LLDP operating mode to Rx on GigabitEthernet 2/1/2.

[RouterA-GigabitEthernet2/1/2] lldp admin-status rx

[RouterA-GigabitEthernet2/1/2] quit

2. Configure Router B:

# Enable LLDP globally.

<RouterB> system-view

[RouterB] lldp global enable

# Enable LLDP on GigabitEthernet 2/1/1. By default, LLDP is enabled on ports.

[RouterB] interface gigabitethernet 2/1/1

[RouterB-GigabitEthernet2/1/1] lldp enable

# Set the LLDP operating mode to Tx on GigabitEthernet 2/1/1.

[RouterB-GigabitEthernet2/1/1] lldp admin-status tx

[RouterB-GigabitEthernet2/1/1] quit