R0106-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V7)

[DeviceA] interface gigabitethernet 2/1/3

[DeviceA-GigabitEthernet2/1/3] port link-aggregation group 2

[DeviceA-GigabitEthernet2/1/3] quit

[DeviceA] interface gigabitethernet 2/1/4

[DeviceA-GigabitEthernet2/1/4] port link-aggregation group 2

[DeviceA-GigabitEthernet2/1/4] quit

2. Configure Device B in the same way Device A is configured.

Verifying the configuration

# Display detailed information about all aggregation groups on Device A.

[DeviceA] display link-aggregation verbose

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Port Status: S -- Selected, U -- Unselected

Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,

D -- Synchronization, E -- Collecting, F -- Distributing,

G -- Defaulted, H -- Expired

Aggregate Interface: Route-Aggregation1

Aggregation Mode: Static

Loadsharing Type: Shar

Port Status Priority Oper-Key

--------------------------------------------------------------------------------

GE2/1/1 S 32768 1

GE2/1/2 S 32768 1

Aggregate Interface: Route-Aggregation2

Aggregation Mode: Static

Loadsharing Type: Shar

Port Status Priority Oper-Key

--------------------------------------------------------------------------------

GE2/1/3 S 32768 2

GE2/1/4 S 32768 2

The output shows that:

• Link aggregation groups 1 and 2 are both load-shared Layer 3 static aggregation groups.

• Each aggregation group contains two Selected ports.

# Display all the group-specific load sharing criteria on Device A.

[DeviceA] display link-aggregation load-sharing mode interface

Route-Aggregation1 Load-Sharing Mode:

source-ip address

Route-Aggregation2 Load-Sharing Mode:

destination-ip address

The output shows that:

• The load sharing criterion for link aggregation group 1 is the source IP address.

• The load sharing criterion for link aggregation group 2 is the destination IP address.