R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

101
Default
An interface is not assigned to any HDLC link bundle.
Views
POS interface view, serial interface view
Predefined user roles
network-admin
Parameters
bundle-id: Specifies an HDLC link bundle by its number in the range of 1 to 10.
Usage guidelines
An interface can be the member of only one HDLC link bundle. To move an interface from one HDLC link
bundle to another HDLC link bundle, remove the interface from the current HDLC link bundle first.
You must enable HDLC encapsulation on an interface to be assigned to an HDLC link bundle. You cannot
change the link layer protocol encapsulation of an HDLC link bundle member interface.
You can assign interfaces to an HDLC link bundle before you create the HDLC link bundle.
Examples
# Assign POS 2/2/0 to HDLC link bundle 1.
<Sysname> system-view
[Sysname] interface pos 2/2/0
[Sysname-Pos2/2/0] bundle id 1
bundle load-balance
Use bundle load-balance to configure the load balancing mode for an HDLC link bundle interface.
Use undo bundle load-balance to restore the default.
Syntax
bundle load-balance { per-flow | per-packet }
undo bundle load-balance
Default
Per-packet load balancing is used.
Views
HDLC link bundle interface view
Predefined user roles
network-admin
Parameters
per-flow: Specifies per-flow load balancing.
per-packet: Specifies per-packet load balancing.
Usage guidelines
The following load balancing modes are available: