R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

110
Field Description
Last clearing of counters
Last time when the statistics for the interface were
cleared by using the reset counters interface
command. Never indicates that the statistics for the
interface were never cleared by using the reset
counters interface command.
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec,
0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec,
0 packets/sec
Average incoming and outgoing traffic rates on the
interface in the last 300 seconds.
Input: 32 packets, 1842 bytes, 0 drops
Incoming traffic size in packets and bytes and the
number of dropped incoming packets on the interface.
Output: 27 packets, 1512 bytes, 0 drops
Outgoing traffic size in packets and bytes and the
number of dropped outgoing packets on the interface.
Brief information on interface(s) under route mode Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby - standby
Link status:
• ADM—The interface has been administratively shut
down. To recover its physical state, perform the
undo shutdown command.
• Stby—The interface is operating as a backup
interface. To see the primary interface, use the
display interface-backup state command.
Protocol: (s) – spoofing
If the data link layer protocol state of an interface is
shown as UP, but its link is an on-demand link or not
present at all, the protocol attribute includes the
spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The interface is up.
• ADM—The interface has been administratively shut
down. To bring up the interface, perform the undo
shutdown command.
Protocol
Date link layer protocol state of the interface:
• UP—The data link layer protocol state of the
interface is up.
• DOWN—The data link layer protocol state of the
interface is down.
• UP(s)—The data link layer protocol state of the
interface is shown as UP, but its link is an
on-demand link or not present at all.
Main IP
Main IP address of the interface. Two hyphens (--)
indicate that no main IP address is configured for the
interface.