R0106-HP MSR Router Series Layer 2 - WAN Command Reference(V7)

123
SPID Type: AUTO
SPID B1:
SPID Num: 235
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID B2:
SPID Num: 326
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information for the NI-enabled interface BRI 2/4/0 (the SPID type is STATIC).
<Sysname> display isdn spid interface bri 2/4/0
Interface Bri2/4/0:
SPID Type: STATIC
SPID B1:
SPID Num: 134
LDN: 3251
Init State: INIT_NULL
SPID B2:
SPID Num: 257
LDN: 3657
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information on the NI-enabled interface BRI 2/4/0 (the SPID type is NIT).
<Sysname> display isdn spid interface bri 2/4/0
Interface Bri2/4/0:
SPID Type: NIT
Table 23 Command output
Field Descri
p
tion
SPID Type
SPID assignment type:
• NIT—Not initial terminal mode. You must enable NIT mode on the BRI interface if the
NI-type service provider switch does not support SPID negotiation.
• STATIC—Static SPID assignment. You must manually configure the SPIDs assigned by
the service provider on the BRI interface.
• AUTO—Dynamic SPID assignment. The interface obtains SPIDs dynamically from the
service provider switch.
SPID B1 SPID information for the B1 channel on the BRI interface.
SPID B2 SPID information for the B2 channel on the BRI interface.